ATI Install

From OSx86
Revision as of 12:56, 12 April 2011 by Tom (Talk | contribs)

Jump to: navigation, search

To enable native QE graphics output on an ATI graphics adapter, you always need a framebuffer.

Either a pre-definded framebuffer can be used, or you can patch an existing one to match your graphics adapter's configuration of DVI/HDMI/VGA/Displayport.

Pre-definded Framebuffer

You can choose from the pre-defined framebuffer with Kaby's edition of the Chameleon boot loader. Example:

AtiConfig=Shrike

Patching Framebuffer

The patching was discovered by bcc9 in this thread. mucha made a guide howto patch.

Powered by MediaWiki © 2021 OSx86 Project  |   InsanelyMac  |   Forum  |   OSx86 Wiki   |   Privacy policy   |   About OSx86   |   Disclaimers